LIQUID APPLICATION INSTRUCTIONS FOR A MOUSING SURFACE

1. Clean surface to remove any oils, debris, and dirt. Let dry.
2. Shake LIQUID well and place a small puddle (approximately the size of a dime for a surface size up to 10"x10") in middle of surface and wipe around evenly in circles with a lint free sponge (included) or cloth. Very little is needed to reduce friction, therefore do not over-apply LIQUID as it can fill in textured surfaces.
3. Surface may be used immediately once dry (within minutes after treatment.) Full cure treatments are more durable. Full cure is 24 hours.
4. A blow dryer may be used to "cure" LIQUID more quickly on pads and feet.
5. Re-treat as needed (depending on use can be approximately once per week up to once per month)

LIQUID APPLICATION INSTRUCTIONS FOR MOUSE FEET

1. Clean mouse feet by wiping off any debris and buildup.
2. Isopropyl alcohol can be used if heavy cleaning is needed. If a Teflon tape product has been used on the feet, all glues MUST be removed for proper `slickness' to be achieved.
3. Turn mouse upside down and support it so it stays level.
4. Shake LIQUID well and place small amount on each mouse `foot'. Allowing for a level coating over entire mouse `foot'.
5. Using the included sponge, even out the drop on top of the mouse foot.
6. Let dry before use.

Keep LIQUID out of the optical eye port if you use an optical mouse. If contact occurs, wipe LIQUID out immediately.

** As with all household chemicals; keep out of reach of children and do not ingest**